Fire Exit Door Handle Requirements

Hardware consisting of bars that extend to at least half of the width of the door leaf.
Fire exit door handle requirements. 1910 36 a 1 an exit route must be permanent. Only fire rated hardware may be fitted to fire rated doors. The door should open in the direction of evacuation. And one that can be easily used at all light levels.
There should be no locks or catches. Exit routes must meet the following design and construction requirements. Many use a push bar system that will open the door when pressed down. It shall not be locked barred or bolted at any time while the building is occupied.
Each exit route must be a permanent part of the workplace. Locks must be fitted at a height of between 900mm and 1100mm from the floor level. Fire doors must also be fitted with an as1905 1 fire rated automatic door closer. For instance a latch or some other fastening device is a requirement for doors with a simple releasing device.
A fire rated automatic door closer must also be fitted. Sps 375 24 3 3 a standard exit door shall have such fastenings or hardware that it can be opened from the inside without using a key by pushing against a single bar or plate or turning a single knob or handle. The final fire exit door must. There are also additional requirements where the door is the final exit point of a building.
1910 36 a 2 an exit must be separated by fire resistant materials. It is not permissible to have a hold open feature on either the lock or door closer.