Fire Sprinkler Testing Procedure

During a complete fire sprinkler system test the technician should perform physical checks on all parts of your fire sprinkler system.

Fire sprinkler testing procedure. If you have a fire sprinkler system you don t actually need to test it right. Regular fire sprinkler inspection testing and maintenance itm is required by the ifc international fire code and the nfpa national fire protection association codes 1 101 5000. Specific requirements relating to the inspection testing and maintenance of fire pumps can be found in chapter 8 of nfpa 25. While one technician is stationed at the fire alarm panel located in the basement the second technician is in the attic inspecting the.

Inspecting testing the fire sprinkler system. 5 year testing on sprinkler systems the following guideline shall be referenced as the standard operating procedure to conduct five year tests of fire sprinkler systems. During this time period the system piping is inspected for leaks. Connection caps fdc.

It does not apply to buildings with an nfpa 13d system. Nfpa 13 pressure test procedures aboveground fire systems. A hydrostatic test is a pressure test to reveal the presence of leaks in the piping system. The inspection testing and maintenance requirements that apply to your building s fire sprinkler system start.

Only buildings with an nfpa 13 or nfpa 13r system are covered by this guideline. Sure testing is performed to comply with nfpa regulations insurance requirements and to keep you out of trouble with the fire department ahem violations. System has under 300 sprinklers no less than 6 system has 300 1 000 sprinklers no less than 12 system has over 1 000 sprinklers no less than 24 nfpa 25 5 4 1 5 spare sprinkler wrench nfpa 25 5 4 1 5 5 signage i e all valves main drain open close valve inspector test valve. Please use the free resources below to assist you with inspections testing and maintenance of fire sprinkler systems.

Testing and maintenance of water based fire protection systems. Read more from capitol fire sprinkler a service provider in nyc. A fire protection system requires regular inspection and testing to ensure it works in an emergency and one of the essentials is a hydrostatic test also known as a functionality test. For fire protection systems the piping is pressurized to 200 psi 13 8 bar for a period of 2 hours.

On this day the team of two koorsen systems technicians are inspecting one of the older buildings that used to be a residence back during the civil war. Nfpa 25 13 8 1 fire dept. In table 5 1 1 2 correct the cross references to read as follows.